THE most precise little thing i have ever flown. Nobody beats the Whoop indoors. With my lipos and the MWH middle motors i am still missing a bit of power outdoors. Not sure if i would buy it again because of the price (expensive Inductrix and Motors)

Based on my H8 Frame below, i made a slightly bigger version with 8.5mm Motors and Hubsan X4 Props. This time i chose a brushed F3 flightcontrol with an Frsky compatible RX. This bigger version handles my Eachine EF-01 Cam without any problem.

The very light custom H8 frame with the FX797T Cam makes a really nice outdoor garden FPV Flyer. Lots of power and impressively fast.

Changed the Roll Rate for acro mode to 720 degree per sec (#define MAX_RATE 720.0). Requires some expo to fly now, but flips work just fine now.

Download the Frame plan: h8_public.dxf.zip

First impressions of the new Eachine EF-01 AIO Cam were not too good. nearly 3g heavier than the FX797T and lots of noise and lines in the image when motors spin. H8 can handle the weight quite well and after adding a capacitor in parallel with the cams power most of the noise is gone.

First Conclusion: Stock H8 + cheap Eachine EF-01 Cam and small mod makes a nice and cheap Starter Kit! If you can efford the better FX797T cam, consider buying that one.

2nd Conclusion: After getting a 2nd one of the Eachine EF-01 Cams, i mentiones that the PCD design of the cams has changed. The newer one does not have the metal shielding between the two PCBs and bigger capacitors on the power regulation which result in less image noise. Additionally the newer one is 0.7g less in weight. This makes the cam even better for the H8. Modded the stock H8 with a firmware flashing connector and removed a part of the top-case to fit the cam a bit better. Pretty happy with it now. Flies nice and gives 3:20min of FPV-Fun

This small and cheap module enables you to fly the H8 with nearly any Transmitter that has either a module bay or a trainer port. You can find the schematics in the gallery below. The module uses pascallangers Multi Module Code, but for Bayang protocol only.

• Devo 7e Modded Devo 7e Transmitter with Deviation Firmware and multi protocol.
• Tiny Whoop Main Website
• Tiny Whoop Thread @ FPV Community
• Eachine H8 Thread @ FPV Community
• Eachine EF-01 Cam Thread @ rcgroups
• Eachine E010 Inductrix Clone @ RCGroups
• micro-motor-warehouse Inductrix Upgrade Motors
• Eachine H8 Flashing tutorial
• Eachine H8 Flashing for linux
• The Silverware Wiki flashable micro quad overview

H8 starts at 2:30

So much fun outside with this little beast!

Eachine H8 FPV

Testing my FPV Modded Eachine H8. Still trouble with the recording, live image looks much better. First part flown with the modded stock H8, 2nd half with my new custom Frame. Lighter frame give to much thrust and causes trouble with the PIDs on full battery.

Eachine H8 FPV - Low Battery Mod